HiModel
2.4G CORONA DSSS 14-CHANNEL RECEIVER CR14
| Type | CR14 DSSS |
| Size | 37.5X52.5X16MM |
| Weight | 21g |
| Range | >1500M |
| Sensitivity | -100dbm |
| Operating voltage | 4.8V-6V |
| Operating current | 40mA |
| Compatible with | CT14F |
, , , , , , Specifications:, , , , , , , , , , , Receiver Specs:, Number of Channel: 14, , ,
Features: The new lightweight, advanced technology unit has the following ...1 Reviews
HiModel
2.4G CORONA DSSS 14-CHANNEL RF MODULE & RX SYSTEM FOR FUTABA TRANSMITTER (RF CT14F, RX CR14)
| Type | CT14F DSSS |
| Size | 54X30X25MM |
| Weight | 27g |
| Operating voltage | 5V (Futaba) |
| Operating current | 150mA |
| Compatible with | FUTABA |
| Type | CR14 DSSS |
| Size | 37.5X52.5X16MM |
| Weight | 21g |
| Range | >1500M |
| Sensitivity | -100dbm |
| Operating voltage | 4.8V-6V |
| Operating current | 40mA |
| Compatible with | CT14F |
, , , , , , Specifications:, , , , , , , , , , , RF Module Specs:, Output Power: , Receiver Specs:, Number of Channel: 14, , ,
Features: The new lightweight, advanced technology unit has the following ...6 Reviews
HiModel
CORONA 2.4GHZ DIY DSSS TRANSMITTING MODULE AND RECEIVER CT8Z/CR8D
| Type | CT8Z DSSS |
| Size | 38.5*21.8*6.5mm |
| Operating voltage | 8V-13V |
, , , , , , Specifications:, , , , , , , , , , , Weight: 5g, Operating current: , Output Power:, ,
Features: Features of Corona 2.4GHz DIY transmitting module and receiver ...3 Reviews
HiModel
WFT06II 2.4GHZ 6-CHANNEL RADIO SYSTEM
| Model | WFT06II |
| Use in | Airplane,Helicopter,Car,Boat |
| Band | 2.400-2.483GHz |
| Output Power | ≤100mW |
| Modulation | 2.4GHz DSSS(spread Spectrum)+Frequency Hopping |
| Memory | 8-model memory |
| Power | 3.7-6.0V ≤190mA |
| Transmitter programe language | English |
, , , , , , Specifications:, , , , , , , , , , , Transmitter stick mode: both mode 1 and mode 2 are available, mode 2 (throttle on left hand) will be sent by default. If you need mode 1, you can specify the stick mode in the Remark field on the last step when place the order., , ,
Features: THIS IS THE NEW WFT06II. ● Great choice for ...2 Reviews
HiModel
WFT07 2.4GHZ 7-CHANNEL RADIO SET W/ WFR07S RECEIVER （10 MODEL MEMORY)
| Model | WFT07 |
| Applications | helicopters,airplane,vehicles,boat |
| Band | 2.4Ghz DSSS(spread Spectrum)+Frequency Hopping |
| Output Power | ≤100mW |
| Current drain | ≤190mA |
| Power | 3.7V-6V |
| Transmitter manual language | English |
, , , , , , Specifications:, , , , , , , , , , , Stick mode: Mode 1 (throttle on right hand) and mode 2 (throttle on left hand) is optional, mode 2 will be sent by default if not specified., *This transmitter uses 3.7V-6V power supply, TX battery higher than 6V may burn the radio and NOT covered by warranty., , ,
Features: ● Large dot matrix LCD.Resolution of 132×64. ● 10class ...13 Reviews
HiModel
HIMODEL LED 1-8S LIPO BATTERY VOLTAGE TESTER/ LOW VOLTAGE BUZZER ALARM (1S SUPPORT 3.7-30V)
| - Total voltage display range | 0.5 - 36V |
| 1S test mode voltage range | 3.7-30V |
| - Alarm set value range | OFF-2.7-3.8V |
| - Weight | 8.7g/ 0.31oz |
, , , , , , Specifications:, , , , , , , , , , , - Use for 1-8S Lipo/LiMn/Li-Fe, - Voltage detection precision ±0.01V, - Unit voltage display range 0.5-4.5V, -, - Low voltage alarm mode for 2-8S, When the voltage is below the set value, it will buzzer with red LED light, pre-set value 3.3V., Push key which can change the voltage settings and save., * Friendly remind:, The sound of the low voltage alarm is very big, so please be prepared when use it for the first time, and you can turn it OFF when use indoors., , ,
Features: THIS IS BATTERY VOLTAGE CHECKER AND LOW VOLTAGE BUZZER ...HiModel
G.T.POWER CCPM SERVO CONSISTENCY MASTER / SERVO TESTER
| Voltage consumption | DC4.8-6V |
| Size | 48 x 42 x 17mm |
| Weight | 31.5 g |
, , , , , , Specifications:, , , , , , , , , , , , ,
Features: The device also can be used as a signal ...3 Reviews